Using Detergent - Power Fist 8458804 Manuel D'utilisateur

8458804
ASSEMBLY
NOTE: When this manual refers to a part number, it refers to the included Parts Identification section.
1. Make sure that the ON/OFF switch is in the OFF position.
2. Attach garden hose to water supply. (Fig. 2). Attach other end to the water
inlet on the pressure washer.
NOTE: The water hose must be at least 1/2 in. in diameter. The water supply
must have a flow of at least 4-1/2 GPM and a pressure between 22 and
87 PSI. The water supply temperature must not exceed 40°C (104°F).
3. Attach the hose connector (#6) of the high-pressure hose to the water
outlet (#1). Twist tightly to avoid leakage.
4. Thread the hose connector (#5) of the high-pressure hose onto the spray gun (#10).
5. Turn water on.
6. Thread the wand (#11) onto the spray gun.
7. Plug the power cord (#2) into an electrical outlet.
OPERATION
1. Prepare the work area for cleaning, including ensuring all doors and windows are closed tight.
2. Before turning the unit ON, squeeze the trigger to bleed any trapped air out of the pump and hose.
3. Start the pressure washer by turning ON/OFF switch to ON (1) position.
4. Move the trigger lock (#9) out of the way and begin spraying by squeezing the trigger.
NOTE: The trigger lock prevents the trigger from accidentally being engaged.
This safety feature does not lock trigger in the "ON" position.
NOTE: To prolong the life of the unit, it is recommended to let the unit rest for 5
minutes after every 30 minutes of use.
5. The nozzle of the adjustable wand (#10) can be adjusted from fan to jet by
turning the nozzle as shown. (Fig. 3)
CAUTION: The jet spray setting is very aggressive. Do not adjust while spraying. We recommend that for most
cleaning applications, a 20° spray angle should be used to avoid damage to the surface being sprayed.

USING DETERGENT

To enhance the efficiency of the pressure washer, sometimes it is necessary to use detergents to help loosen tough
dirt and grime.
1. Remove the adjustable spray wand (#11).
2. Thread the detergent spray wand onto the spray gun (#10)
3. Fill the detergent container with detergent.
4. Thread the container onto the detergent spray wand.
5. Squeeze the trigger and the detergent will be automatically injected and mixed with water.
6. Apply detergent to work area. Do not allow detergent to dry on surface.
7. To rinse, remove the detergent spray wand and re-attach the adjustable spray wand. Squeeze the trigger and
rinse the surface in a sweeping motion.
CAUTION: This unit has been designed for use with pressure washer detergents only. The use of other
detergents or chemicals may damage the unit.
Visit www.princessauto.com for more information
1.6 GPM @ 1,740 PSI Electric Pressure Washer
V 3.0
FIG. 2
FIG. 3
5