Wear Parts - Oase ProfiClear Premium Notice D'emploi

10 Storage/Over-wintering
The unit is protected from frost:
The unit can be operated as long as the water temperature does not go below +4 °C.
Set the interval for time-dependent cleaning to 20 minutes to avoid damage to the rinsing device in
►
the event of frost.
Install the control system in such a way that it is protected. The minimum operating temperature of
►
the control system is -10 °C.
The unit is not protected from frost:
Take the unit out of operation at water temperatures below +8° C or, at the latest, when freezing
temperatures are to be expected.
Drain the unit as far as possible, clean thoroughly and check for damage.
►
Empty all hoses, pipes and connections as far as possible.
►
Leave the slide valves open.
►
Cover the filter container to prevent the penetration of rain water.
►
Protect pipes and slide valves that are in contact with water from frost.
►
Maintain the drum seal after the end of winter or at the beginning of the pond season.
Remove old grease. Then sparingly apply new grease to the edge of the drum. (→ Remove/fit the
►
filter drum)
11

Wear parts

The screen elements, safety fuse, drum seal and capacitor of the rinsing pump are wear parts.
Do not open the rinsing pump. Send the rinsing pump to OASE. You will be sent an immediate
►
replacement.
12 Disposal
Support us in our endeavour to keep our environment intact, and adhere to the following disposal
information!
Dispose of the unit in accordance with the national legal regulations.
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided. Disable the unit
beforehand by cutting off the cables.
- GB -
67