Note: If the food to be processed sticks in
the continuousfeed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuousfeed shredder
and empty feed tube.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuousfeed shredder in
an anticlockwise direction and remove.
■ Rotate the lid in an anticlockwise
direction and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Figure J).
■ Clean parts.
Blender
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until
the drive is at a standstill! Operate the
assembled blender only and with the lid
attached.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a max. 0.5
litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deepfrozen ingredients (except ice cubes).
Do not operate blender when empty.
Working with the blender
Figure K:
■ Press the release button and
move the swivel arm to
position 4.
■ Remove the blender drive cover.
■ Attach blender jug (mark on the handle
on mark on the base unit) and turn all the
way in an anticlockwise direction.
All manuals and user guides at all-guides.com
■ Add ingredients.
■ Attach the cover and turn anticlockwise
■ Set the rotary switch to the desired
Adding more ingredients
Figure K-8:
■ Switch off the appliance with the rotary
■ Remove the lid and add ingredients.
or
■ remove the funnel and gradually add solid
or
■ pour liquid ingredients through the funnel.
After using the appliance
■ Switch off the appliance with the rotary
■ Rotate the blender in a clockwise
Tip: It is recommended to clean the blender
immediately after use.
Cleaning and servicing
The attachments and accessories used
must be thoroughly cleaned after each use.
Attention!
Do not use abrasive cleaning agents. Sur
faces may be damaged.
Cleaning the base unit
W Risk of electric shock!
Never immerse the base unit in water or
place under running water. Do not use a
steam cleaner.
■ Remove mains plug.
■ Wipe the base unit and drive cover with
■ Then dry the base unit.
Cleaning and servicing
Maximum capacity – liquid = 1.25 litres;
maximum capacity frothing or hot liquids
max. 0.5 litres; optimal processing
c apacity – solids = 50100 g;
all the way into the blender handle. The
cover must be locked in position.
setting.
switch.
ingredients through the refill opening.
switch.
direction and remove.
a damp cloth. If required, use a little
detergent.
en
23