After Using The Appliance / Cleaning; Troubleshooting - Bosch MFQ4 Série Mode D'emploi

en After using the appliance / cleaning
W Risk of injury from rotating drive!
Never grip the rotating tools. Do not attach
or remove tools until the appliance is at a
standstill – when switched off, the appliance
continues running briefly. Protect long hair
or loose items of clothing to prevent them
from becoming caught in the rotating tools.
■ Before using the appliance for the first
time, clean base unit and tools.
X Fig. B
■ Completely unwind the power cord.
■ Place the required tool on the base unit
and depress until it locks into position.
Note the shape of the plastic
parts to prevent mixing them up
(see Fig.B-1)!
■ Insert the mains plug.
■ Place the food in a suitable receptacle.
■ Insert tools into the receptacle and
switch on the appliance at the required
setting.
Settings 1, 2:
for working in and mixing in.
Settings 3, 4, 5:
for kneading and beating.
■ After working, set the switch to P
and release and remove the tools with
the ejector button.
W Attention:
The ejector button cannot be actuated
unless the switch is in the P position.
Note:
Always switch off the base unit before
taking it out of the blended food.
12
After using the appliance /
cleaning
Important information
The appliance requires no maintenance.
Thorough cleaning protects the appliance
from damage and keeps it functional.
W Risk of electric shock!
Never immerse the base unit in liquids and
do not clean in the dishwasher. Do not use
a steam cleaner! Do not use the appliance
with damp hands.
Warning!
Surfaces may be damaged.
Do not use abrasive cleaning agents.
■ Remove mains plug.
■ Wipe the base unit with a damp cloth
and then wipe dry.
■ Clean the tools in the dishwasher or with
a brush under running water.
Note:
If processing e.g. red cabbage, the plastic
parts will become discoloured by a red film
which can be removed with a few drops of
cooking oil.
X Fig. C
■ The power cord can be wound up to
facilitate storage of the appliance.
■ Attach mains plug to the cable clamp.

Troubleshooting

Switch cannot be moved to settings 1 to 5.
Remedial action:
When the rear aperture is open, selector
switch 1­5 will not function.