What To Do If - Zanussi ZTEB 288 Notice D'utilisation

Emptying the water reservoir
Water extracted from the laundry condenses in-
side the machine and is collected in a reservoir.
The reservoir must be emptied after each drying
cycle to ensure efficient operation when the ma-
chine is next used. The Water reservoir light re-
minds you to perform this operation.
1. Pull out the reser-
voir
Important! The reservoir must be re-inser-
ted correctly.
If this is not done the pilot light Water reservoir
comes on during next drying and the pro-
gramme stops, leaving the laundry damp. The
buzzer will sound.
After inserting the reservoir press the Start/
Pauze (Start/Pause) button again to allow the
programme to continue.

What to do if ...

Troubleshooting by yourself
1)
Problem
Dryer not connected to mains supply.
Dryer does not
Loading door opened.
work.
The Start/Pauze (Start/Pause) button not
pressed.
Incorrect programme set.
Fluff filters clogged.
Unsatisfactory
Heat exchanger clogged.
drying results.
Max. loading exceeded.
Covered ventilation grill.
28
All manuals and user guides at all-guides.com
2. Turn it upside
down and let water
empty
3. Re-fit the reservoir
Possible cause
The condensed water may be used in a
steam iron or to top up a battery, etc. In
this case it must be filtered (e.g. through a cof-
fee filter).
Cleaning the drum
Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents may
form a barely visible lining on the inside of
the drum. The degree to which the laundry has
been dried is then no longer detected reliably.
The laundry is damper than expected when re-
moved from the appliance.
Use a standard domestic cleaner (e.g. vinegar-
based cleaner) to wipe down the inside of the
drum and drum ribs.
Clean control panel and housing
Caution! Do not use furniture cleaners or
aggressive cleaning agents to clean the
machine.
Use a damp cloth to wipe down the control
panel and housing.
Remedy
Plug in at mains socket. Check fuse in fuse
box (domestic installation).
Close loading door
Press the Start/Pauze (Start/Pause) button.
Set suitable programme.
3)
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
2)
3)
www.zanussi.com