Important!
• The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The appli-
ance must therefore not be installed on floors
which are not resistant to high temperatures.
• When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
• Should the appliance be moved, it must be
transported vertically.
• The appliance must not be installed behind
the lockable door, a sliding door a door with a
hinge on the opposite side to that of the ap-
pliance in such a way that a full opening of
the dryer is restricted.
Removing transport safety packaging
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading door
3. Remove foil hose and polystyrene padding
from the machine.
Electrical connection
Details on mains voltage, type of current and the
fuses required should be taken from the type
20
All manuals and user guides at all-guides.com
2. Pull off adhesive
strips from inside ma-
chine on top of drum.
plate. The type plate is fitted near the loading
aperture (see "Product description" chapter).
Warning! The manufacturer declines any
responsibility for damage or injury through
failure to comply with the above safety
precautions.
Should the appliance power supply cable need
to be replaced, this must be carried out by our
Service Center.
Warning! The power supply cable must
be accessible after installing the machine.
Door reversal
To make it easier to load or unload the laundry,
the door can be reversed.
Warning! The door must only be reversed
by an authorised service engineer.
Please contact your local Service Force Centre.
The engineer will carry out the door reversal at
your cost.
Special accessories
• stack kit
Available from your Service Force Centre
or your specialist dealer
These intermediate installation kits can be
used to arrange the dryer and an washing
machine (60 cm wide, front loaded) as a
space-saving washer/dryer stack. The wash-
ing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with the
kit.
• drain kit
Available from your Service Force Centre
or your specialist dealer
Installation kit for direct draining of conden-
sate into a basin, siphon, gully, etc. The con-
densate tank then no longer has to be
drained, it must however remain in its inten-
ded position in the machine.
Read carefully the instructions supplied with the
kit.
• pedestal with the drawer
www.zanussi.com