Zanussi ZTEB 288 Notice D'utilisation page 26

Lange anti-kreuk (Long Anti-crease)
prolongs the anti-crease phase to 90 mins in total.
The laundry remains relaxed and free of creases.
Zoemer (Buzzer)
audible confirmation of:
• cycle end
• anti-crease phase start and end
• cycle interruption
• error
Tijd (Time)
after setting the Tijd (Time) programme. You can
select a programme duration from 10 mins to 2 hrs
in 10-minute steps.
Startuitstel (Delay Start)
allows to delay the start of a drying programme from
minimum of 30 min. to maximum of 20 hours. Press
the Startuitstel (Delay Start) button repeatedly until
the desired delay start is shown on the display
Setting child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all but-
tons and the programme selector. The child lock
can be activated or deactivated by holding
down the Intensief (Intensive) and Lage temp.
(Delicate) buttons simultaneously for 5 seconds.
– Before programme is started: Appliance can-
not be used
– After programme is started: Programme in
operation cannot be changed
The icon appears in the display to indicate
that the child safety device is activated.
The child safety device is not deactivated once
the programme comes to an end.
If you want to set a new programme, you must
first deactivate the child safety device.
Starting the programme
Press the Start/Pauze (Start/Pause) button. The
programme starts.
The programme progress is shown by elapsing
dry time on the LCD.
26
All manuals and user guides at all-guides.com
Changing programme
To change a programme which is running, first
cancel it by turning the programme selector dial
to
the Start/Pauze (Start/Pause) button.
nevertheless there is an attempt to change the
programme on the programme knob, the pro-
gramme progress display and the maintenance
indicators flash. If an option button (excluding
the Zoemer (Buzzer) button) is pressed,
appears on the display. The drying programme
is not however affected by this (laundry protec-
tion).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display
shows the
well as warning lamps:
reservoir (Tank) . If the Zoemer (Buzzer) ) button
has been pressed, an acoustic signal sounds in-
termittently for about one minute.
lowed by an anti-crease phase which lasts
around 30 minutes. The drum rotates at inter-
vals during this phase. This keeps the laundry
loose and free of creases. The laundry can be
removed at any time during the anti-crease
phase. (The laundry should be taken out to-
wards the end of the anti-crease phase at the
latest to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff
3. Remove laundry.
4. Turn the programme selector to
Important! After each drying cycle:
– Clean the micro-fine filter and fine filter
– Drain the condensed water container (See
5. Close the door.
. Select the new programme and press
The programme can no longer be changed
directly once the programme has started. If
anti-crease icon and flashing as
The drying cycles (except from the Wol
(Wool) programme) are automatically fol-
from the micro-fine filter. It is best to use a
damp hand for this purpose. (See "Mainte-
nance and cleaning" chapter.)
chapter "Maintenance and cleaning ")
Filter and Water-
off.
www.zanussi.com