Faults - What To Do - Gaggenau RF 222 Notice D'utilisation

Faults – what to do?
en
Faults – what to do?
3
Before you call customer service, use this table to check whether you can rectify the fault yourself.
F a u l t s – w h a t t o d o ?
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
A warning signal sounds and the Ú button is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food were placed in the appliance.
Display flashes, warning signal sounds and button Ú is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food were placed in the appliance.
Display flashes.
The temperature in the freezer compartment was too warm.
Appliance is not cooling, display and lighting are lit.
Demo mode switched on.
--------
30
All manuals and user guides at all-guides.com
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance"
on page 25
If the temperature is too warm, check temperature again after
a couple of hours.
If the temperature is too cold, check temperature again on the
following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the customer service.
~ "Customer service" on page 31
Press the Ú button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Do not exceed max. freezing capacity.
Press the Ú button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Do not exceed max. freezing capacity.
When button Ú has been pressed, the warmest temperature
reached in the freezer compartment is displayed for 5 sec-
onds. Press the Ú button. The display stops flashing.
Start the appliance self-test.~ "Customer service"
on page 31
When the programme has ended, the appliance switches
over to normal operation.