Before Using Your Appliance For The First Time; Electrical Connection - Gaggenau RF 222 Notice D'utilisation

Installation and connection
en
Before using your appliance for the
first time
1 Remove leaflets, adhesive tape and protective film.
2 Clean the appliance.
~ "Cleaning" on page 29

Electrical connection

Caution!
Do not connect the appliance to electronic energy saver
plugs.
Note: You can connect the appliance to mains-
controlled and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are connected directly to the national
grid. Sine-controlled inverters must be used for isolated
applications. Isolated applications, e.g. on ships or in
mountain lodges, which are not connected directly to
the national grid.
1 After installing the appliance, wait at least 1 hour
before connecting it to prevent damaging the
compressor.
2 Connect the appliance via a correctly installed
socket.
The socket must comply with the following data:
Socket with 220 V ... 240 V
Conductor 50 Hz
Fuse 10 A ... 16 A
Outside Europe: Check whether the indicated
current type of the appliance corresponds with the
values of your power supply. Appliance
specifications are on the rating plate.
~ "Getting to know your appliance"
on page 23
3 Connect the appliance to a socket near the
appliance.
The socket must be freely accessible even after the
appliance has been installed.
22
All manuals and user guides at all-guides.com