Disposal; Trouble Shooting - HOLZMANN MASCHINEN BS712TURN Mode D'emploi

18 STORAGE
Improper storage can damage and destroy important components. Only store packed
or unpacked parts under the intended environmental
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine on the other.
19

DISPOSAL

Observe the national waste disposal regulations. Never dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist dealer,
he is obliged in certain countries to dispose of your old machine properly.
20

TROUBLE SHOOTING

Danger due to electrical voltage! Manipulating the machine with the power supply
up may result in serious injury or death. Before carrying out any troubleshooting
work, always disconnect the machine from the power supply and secure it against
unintentional recommissioning.
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to solve the problem.
Fault
Machine does not start
Saw band does not come to
full speed, no power
Motor gets hot very fast and
has weak performance
Saw band runs in opposite
direction
Machine vibrates
Bad cuts
HOLZMANN MASCHINEN GmbH
NOTICE
WARNING
Possible cause
Machine not connected to power

supply
Fuse of power circuit defect or

not suitable
Cable defect

To long extension cord

Power supply not matching with

motor requirements.
Weak, instable/volatile power

supply
V-belt tension too low

(BS712TURN)
Motor does not receive power on

one or even 2 phases
2 of the 3 leading phases are

switched whether in Plug or
socket
Placed on uneven underground

Motor or any other parts loose

too high descent velocity

unsuitable saw band for cutted

material
worn saw band

saw band not tensioned correctly

saw band guide outbalanced

www.holzmann-maschinen.at
conditions!
Remedy
Check all power connections

Change fuse

Change cable

change to suitable extension

cord with sufficient cross-
section, insulation and length
Let check by electrician

Contact electric power

company
Adjuste V-Belt tension

Shut off machine

immediately. Let the
connection to supply circuit
be checked by an electrician!
Shut off machine
immediately. Let the
connection to supply circuit
be corrected by an
electrician!
modify

check all screw joints if

tightened
Reduce the descent velocity

Use e.g. for stainless steel HQ

Bi-Metal bands only
replace

tension saw band correctly

readjust saw band guide

BS 712TURN; BS712TURN-G
STORAGE
39