Assembly - HOLZMANN MASCHINEN BS712TURN Mode D'emploi

14.2 Assembly

The machine comes pre-assembled, it is necessary to reassemble the components that have been
disassembled for transport according to the following instructions.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
1. Wheel assembly
Slide the axle (1) through the holes in
the machine base.
Attach the washer (2) and wheel. Secure
wheel with cotter pin (3). 2 axles and 4
wheels must be mounted on the
machine..
2. Workpiece stop assembly
Fix the workpiece stop with a screw in
the holder (1).
Position the workpiece stop and fix it
with locking screw (2)
3. Cylinder assembly
Assemble the lowering cylinder (5) at
the lower position (1) on the machine as
shown and secure with the nut (2).
Mount the lowering cylinder at the upper
position (3) using the bolt (4).
4. Assembly vertical table (optional)
Assemble the table support strut (2)
to the machine using the screw (1).
Remove screws (3) on the saw blade
guide. Thread the table (4) on the
saw blade, align the holes on the saw
blade guide and support and fix it to
the machine with the two screws (3)
and screw and nut (5).
5. Assembly support feet
Attach the two support feet (1) to the
machine with 2 screws, washers,
spring washers (2) each.
ASSEMBLY
31
BS 712TURN; BS712TURN-G