KitchenAid KFDD500ESS Instructions D'installation page 14

Masquer les pouces Voir aussi pour KFDD500ESS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Unscrew the regulator cap, and then remove the plastic
cover.
A. Plastic cover
B. Regulator cap
3. Flip the regulator pin over, and then replace the plastic cover.
A
A. Natural gas position
B. LP gas position
C. Plastic cover
4. Screw the regulator cap securely back into place. Do not
overtighten.
To Convert Surface Burners
1. If the burner grates are installed, remove them.
2. Remove the burner caps.
3. Using a Phillips or T20
®
base.
A
B
A. Burner cap
B. Gas tube opening
14
A
B
B
C
Torx
®
screwdriver, remove the burner
C
D
C. Burner base screws
D. Burner base
4. Apply masking tape to the end of a ⁹⁄₃₂" (7.0 mm) nut driver to
help hold the Natural gas orifice spud in the nut driver while
changing it. Press nut driver down onto the Natural gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set the Natural gas orifice spud aside.
A. Natural gas orifice spud
Use the following chart for correct LP gas orifice spud for each
burner. Refer to the model/serial/rating plate behind the control
panel for proper sizing of LP gas orifice spuds for each burner
location.
LP Gas Orifice Spud Chart
Burner Rating
4,000 BTU
7,000 BTU
9,100 BTU
14,000 BTU
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the "LP Gas Orifice Spud Chart."
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with literature package.
10. Replace burner grates.
11. Complete installation. See "Make Gas Connection" and
Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
¼" to ½" (0.64 to 1.3 cm) long. The outer cone is not as
distinct as the inner cone. LP gas flames have a slightly
yellow tip.
IMPORTANT: You may have to adjust the low setting for each
cooktop burner.
A
Color
Number
Blue
64L
Black
81L
Green
97L
Red
114L

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kdrs505xss

Table des Matières