Dmx-Protocol; Cleaning And Maintenance - Futurelight WL-250 Mode D'emploi

Occupation of the DIP-switches:
Setting the DMX-
starting address:
Projector number
& channels
Device 1 - channels 1-4
Device 2 - channels 5-8
Device 3 - channels 9-12
Device 4 - channels 13-16
Device 5 - channels 17-20
Now you can start operating the WL-250 via your lighting controller.

DMX-protocol

Control channel 1 -– Magenta
DMX-value Feature
0-255 Magenta (0=white, 255=magenta)
Control channel 2 – Yellow
DMX-value Feature
0-255 Yellow (0=white, 255=yellow)
Control channel 3 – Cyan
DMX-value Feature
0-255 Cyan (0=white, 255=cyan)
Control channel 4 – Shutter/Dimmer

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) Mechanically moved parts like axles, eyes and others must not show any traces of wearing (e.g. material
abrading or damages) and must not rotate with unbalances.
4) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Disconnect from mains before starting maintenance operation!
All manuals and user guides at all-guides.com
1 2
DIP-switch no.
DMX-starting
1 2
address
On
Off Off
On
Off
On
Off
On
Off
On
Off
DANGER TO LIFE!
23/45
3 4 5 6 7 8
16
4 8 32 64 128 256
9
51833575_V_1_0.DOC