Installation; Installing/Replacing The Lamp; Danger To Life - Futurelight WL-250 Mode D'emploi

INSTALLATION

Installing/Replacing the lamp

For the installation, you need one of the following lamps:
OMNILUX OSD 90V/250W GX-9,5 2000h 6700K
OSRAM HSD250 90V/250W GY-9,5 2000h
SYLVANIA BA250/2 SE D 90V/250W GY-9,5
PHILIPS MSD250 90V/250W GY-9,5 2000h
OSRAM HSD250/2 90V/250W GY9,5 3000h 7800K
PHILIPS MSD250/2 90V/250W GY-9,5 2000h
The lamp must only be changed when wearing appropriate protective clothing (protection glasses, protection
gloves, helmet with sight, leather apron).
The lamp life given by the manufacturer must never be exceeded. This is why you need to take notes on the
operational time of the lamp and replace the lamp in time.
Keep exchanged lamp in a protective container and remove accordingly.
During the operation, the lamp reaches temperatures of up to 600° C.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 10 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Unscrew the lens screws.
Step 2: Remove the lens.
Step 3: Unscrew the reflector screws and remove the reflector.
Step 4: If replacing the lamp, remove the old lamp from the lamp holder.
Step 5: Insert the lamp into the lamp holder.
Step 6: Replace the reflector.
Step 7: Replace the lens.
Step 8: Tighten the lens screws.
All manuals and user guides at all-guides.com

DANGER TO LIFE!

Only install the lamp with the device switched off!
Unplug from mains before!
No. 89106005
No. 89106010
No. 89106120
No. 89106015
No. 89106110
No. 89106115
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened cover!
19/45 51833575_V_1_0.DOC