Setting Electronic Clock; Setting Electronic Timer; Oven Light; Automatic Oven Shutoff - Amana ARG7303 Serie Manuel Du Propriétaire

Setting Electronic Clock

Electronic clock has 3 modes—Clock displayed, set
clock (flashing), and clock not displayed. Press CLOCK
pad to advance through modes.
When power is connected or restored, display flashes
until pad is pressed or temperature knob is turned. Reset
clock.
1. Verify display is flashing.
• If display does not flash, press CLOCK pad repeat-
edly until display flashes.
2. Press HRS + or - pad to set hours and MINS + or -
pad to set minutes.
3. Press CLOCK pad to save time-of-day.
• Clock saves time-of-day approximately 60 seconds
after time is entered if CLOCK pad is not pressed.
Turning Off/On Clock Display
Press CLOCK pad until display is blank. Clock retains
time while not displayed. To turn on display, press
CLOCK pad until time-of-day displays and is not flashing.

Setting Electronic Timer

The minute timer is a timer only. Electronic timer does not
control bake, broil, or self-clean function. Timer can be set
up to 11 hours and 59 minutes.
1. Press TIMER pad.
2. Press HRS + or - pad to set hours and MINS + or -
pad to set minutes.
• Timer begins counting down automatically after
time is entered.
• To view clock while timer counts down, press
CLOCK pad. To view timer again, press TIMER pad.
3. Press TIMER pad again to cancel.
• After time elapses, timer beeps approximatly once
a second until TIMER pad is pressed.
Resetting and Canceling Timer
To reset or cancel timer, display must show remaining
time. If display does not show remaining time, press
TIMER pad.
To reset the time when remaining time is displayed, press
the HRS + or - pad to set hours and MINS + or - pad to
set minutes until new time displays.
To cancel timer when remaining time is displayed or
signal after time elapses, press TIMER pad.

Oven Light

Brightens oven cavity when oven door is opened or panel
switch (some models) is turned on.
All manuals and user guides at all-guides.com

Automatic Oven Shutoff

As a safety feature, oven control automatically shuts off
oven after 12 hours of operation. This feature can be
turned on or off.
To allow the oven to operate for more than 12 hours,
confirm temperature knob is in OFF position. Then, press
and hold the MINS + and - pads for approximately
4 seconds. Display will change from time-of-day and show
"OFF".
To set oven to shut off after 12 hours, confirm temperature
knob is in the OFF position. Then, press and hold the
MINS + and - pads for approximately 4 seconds. Display
will change from time-of-day and show "ON".

Service Tones and Codes

Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows an "F-code" in display when there is a
problem. When electronic range control signals a
problem, follow steps listed below.
1. Record "F-code" shown.
• FFF—control malfunction.
• F2—high oven temperature.
• F3—open temperature sensor or circuit malfunc-
tion.
• F4—shorted temperature sensor or circuit malfunc-
tion.
2. Disconnect electrical supply.
• Disconnecting electrical supply may eliminate "F-
code". If failure continues, contact an authorized
servicer.
3. Contact an authorized servicer to check range.
17