Amana ARG7303 Serie Manuel Du Propriétaire page 10

Converting Oven Burner for Use with LP\Propane
1. Remove storage drawer.
• See Removing Storage Drawer section.
2. Locate and remove 2 screws attaching Z-shaped
cover plate.
• Cover plate located in center, rear of storage drawer
cavity.
• Removing cover plate exposes oven burner orifice
and air shutter.
3. Turn orifice hood clockwise until snug.
• Do not overtighten orifice hoods. Orifice hoods can
strip.
4. Replace cover plate and storage drawer.
C
A
B
A—Air Shutter Screw
B—Orifice Hood
C—Air Shutter
Converting Oven Burner
Converting Broiler Burner for Use with LP\Propane
1. Locate orifice spud attached adjacent to pressure
regulator and remove for later use.
• Orifice spud used for LP/propane gas is silver and
is stamped "58".
2. Open oven door and locate broiler burner on oven
ceiling.
• Remove oven door to make conversion easier. See
Removing Oven Door section.
3. Remove 2 screws securing front of burner to oven
ceiling and remove broiler.
• Be careful not to damage ignitor while removing
broiler.
4. Unscrew natural gas burner spud stamped "52"
All manuals and user guides at all-guides.com
5. Reinstall broiler and, if necessary, oven door.
Converting Type 1 Pressure Regulator for Use with
Natural Gas
1. Remove pressure regulator cap with a wrench.
2. Remove plastic insert from pressure regulator cap.
3. Reverse plastic insert and carefully push plastic insert
4. Place pressure regulator cap on pressure regulator
Converting Type 2 Pressure Regulator for Use with
Natural Gas
1. Remove pressure regulator cap with a wrench.
2. Reverse pressure regulator cap.
3. Place pressure regulator cap on pressure regulator
10
5
with / inch socket wrench and replace with LP/
16
propane burner spud stamped "58".
• Attach unused burner spud near regulator for future
use.
B
A
A—Screw
B—Broiler
C—Spud/Oriface
Converting Broiler Burner
• Plastic insert fits tightly in cap.
firmly into hole in pressure regulator cap.
• Insert must show "NAT" or be blank.
and tighten.
• Insert should not disturb spring in body of regulator.
• Insert shows "NAT" or is blank.
and tighten.
C