Center Of Gravity (Cg); Control Direction Tests - Horizon Hobby E-flite Bind-N-Fly UMX FPV RADIAN Mode D'emploi

EN

Center of Gravity (CG)

The CG location is 29mm back from the leading
edge at the wing root.
This CG location has been determined with the
included 1S 150mAh 3.7V Li-Po battery installed
towards the rear of the battery cavity located on the
bottom of the aircraft.
Balance the model on the edge of a metal ruler to
fi nd the Center of Gravity. Place the ruler on the
underside of the airframe at the CG location shown
in the image to the right. Move the battery forward
or aft until the model closely balances at this
location.

Control Direction Tests

Bind your aircraft and
transmitter before doing
these tests.
Move the controls on
the transmitter to make
sure the aircraft control
surfaces move correctly
and in the proper
direction. Make sure
the tail linkages move
freely and that paint or
decals are not adhered
to them.
8
Transmitter
Input
Down Elevator
Up Elevator
Left Rudder
Right Rudder
Control Surface Movement
29mm