Installing Clevises On Control Horns And Control Centering; Factory Settings; Center Of Gravity (Cg) - Horizon Hobby ParkZone T-28 Trojan Manuel D'utilisation

EN

Installing Clevises on Control Horns and Control Centering

Tip: Turn the clevis clockwise or counterclockwise on the linkage.
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis and put the clevis pin into the desired hole in
the control horn.
• Move the tube to tighten the clevis onto the control horn.
After binding a transmitter to the model receiver, set all trims and sub-trims
to 0, then adjust the clevises to center the control surfaces.

Factory Settings

Fly the model at factory settings before making any changes. For pilots who
wish for more control throw, adjust the position of the control linkages on
the servo arms and control horns for increased travel.

Center of Gravity (CG)

Place the battery all the way forward in the fuselage
and hold the battery in place using a hook and loop
strap. It is easiest to balance the T-28 with the
aircraft inverted.
8
1.
2.
3.
63.5mm
(2.5 inches) from the leading edge
of the wing at the fuselage.
4.
5.
6.
Elevator Ailerons
Arms
Horns
Rudder
Nose Gear