First Person View (Fpv) Camera Installation - Horizon Hobby E-flite Bind-N-Fly UMX FPV RADIAN Mode D'emploi

First Person View (FPV) Camera Installation

1. Carefully pull the receiver's FPV power
connector out of the hole of the aircraft's
canopy.
2. Align the wire colors and connect the FPV
power connector to the camera unit.
3. Connect a flight battery to the aircraft, then
remove the lens cap and test the FPV system.
FPV System Test
• Power on headset and ensure it is on CH 1,
ensure no other video transmissions are on
channel 1. If you see another video feed on CH 1
search for an open channel before powering on
your camera.
• The camera is on CH 1 when it is fi rst powered
up, this is indicated by two illuminated LEDs.
each press of the button advances the camera to
the next channel. after channel 7 the next button
press will set the camera back to Channel 1.
Spektrum Ultra Micro
FPV Transmitter Channels
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
4. Ensure the camera points directly forward.
5. Secure the camera unit on the fuselage
using the included double-stick tape. Use the
circular tab on the bottom of the camera
mount to assist with the alignment.
6. Put excess wire in the hole.
5740 MHz
5760 MHz
5780 MHz
5800 MHz
5820 MHz
5840 MHz
5860 MHz
1
3
4
5
EN
2
11