Setting Up An Additional Handset - Topcom Butler 2505 Mode D'emploi

Butler 2505/2510
6. MANAGING MULTIPLE HANDSETS

6.1. SETTING UP AN ADDITIONAL HANDSET

You can subscribe new handsets on the base if these handsets support the DECT GAP protocol.
The base can support a maximum of 5 handsets. If you already have 5 handsets, and you wish to add
another one or change one handset, you must first delete a handset, then associate the new handset.
To register any handset, the base must be put into a special registration mode:
1. Press and hold the paging key
2. The base will then emit a beeptone. The base is now ready to register a new handset. You have 90
seconds after pressing the button to register a new handset.
After putting the base into registration mode, start the procedure on the new handset:
if your additional handset is a butler
2505/2510/2550/2605/2610/2650/2705/2710/2750/2805/2810/2850
3. Enter the menu by pressing /OK
4. Select REGISTER using the
5. Press OK
6. Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.
7. Press OK
8. Enter the BASE PIN code (0000 by default )
9. Press OK. The handset will start searching for the DECT base
10. If the handset has located the base, it will display the base identification number, validate the
base registration by pressing OK or stop by pressing
11. If the handset does not locate the base, it will return to the standby mode after a few seconds.
Try again by changing the base number and check that you are not in a environment where there
is interference. Move closer to the base.
if your handset is another model
After starting the registration procedure on the base, refer to the handset manual to find out how to
register the handset. The handset must be GAP compatible.
The icon and the text "NOT REG" flashes on the display when the handset is not associated with
the base.
When a handset is associated with a base, it is attributed a handset number by the base. It is this num-
ber that is displayed on the handset after the name and must be used for internal calls.
of the base for 6 seconds.
and keys
82
,