EUROM GOLDEN 2000 ULTRA RCD Mode D'emploi page 14

3 – Suspension from a ceiling by means of chains
hook to the chain allows you to raise the suspension height of the heater (see picture).
Please always take account of the minimum distances to the ceiling, floor, walls and
objects!
The following applies for all options:
 However you install the GOLDEN ULTRA (RCD), always lead the electrical cable directly
away from the heater. It may not become hot!
 Adjust the desire radiation angle of the device. Do this by undoing both Allen screws
slightly using the Allen key. Make sure you secure them again once you have made the
adjustments! The heater can rotate through approximately 90° - with wall fastening
from 30° upwards to approximately 60° downwards. When adjusting the angle ensure
that the radiator does not radiate heat onto flammable materials from a short
distance!
 Fasten all screws another time firmly and scheck or the heater is firmly mounted. Now
your infra red heater is ready for use.
 For personal protection the installation, to which the EUROM GOLDEN 2000 ULTRA
(RCD) is connected, has to be equipped with an earth fall device (max. 30 mAmp).
Under some circumstances it may be attractive to make a fast connection between the
heater and the main supply, and to operate the heater with a switch. Because the
EUROM GOLDEN 2000 ULTRA (RCD) has a high water tightness (IP65) and for safety
reasons, such a connection has to be made by a qualified electrician.
WORKING
Check for every use:
- o the applia e does t show sig s o da age
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o
wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is
grounded.
When you use the appliance for the first time (or after a long time again), observe it
during the first 10 till 15 minutes to be sure that is works trouble-free.
All manuals and user guides at all-guides.com
14
 Choose 2 suspension points in the ceiling, 40 cm apart.
Ascertain that the ceiling and fastening materials are
strong enough and suitable to take the weight of the
heater for an extended period of time.
 Fasten the suspension eyes to the ceiling (not supplied).
 Hook one end of the chains onto suspension points of the
heater by means of the karabiner hook. You hook the
karabiner hooks at the other end of the chain through the
suspension eyes in the ceiling. Pulling the chain through
the suspension eye and fastening the second karabiner