Stihl TS 400 Cutquik Notice D'emploi page 34

: Pull the starter rope through the
pulley and secure it in the rope rotor
with a simple knot
TS 400
3
4
: Slip the rope rotor onto the starter
post and turn it back and forth a little
until the anchor loop of the rewind
spring engages
: Replace the pawl (5) in the rope
rotor
: Place the washer (4) on the starter
post
: Press the spring clip (3) onto the
starter post and over the peg of the
pawl with a screwdriver or suitable
pliers. The spring clip must point to
the right, in clockwise direction as
illustrated.
5
Tensioning the rewind spring
: Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow
: Hold the rope rotor tight, pull out the
twisted rope and untangle it
: Release the rope rotor
: Slowly let go of the starter rope so
that it is wound up on the rope rotor
The starter handle must be drawn firmly
into the rope guide bush. If it tips
sideways: increase the spring tension by
another turn.
English
33