Virutex EB140PLC Manuel D'instructions page 42

(Figura 30)
(Figura 31)
42 - EB140PLC Premilling / Annex operating instructions
4.3.3 Grinding of panels without placing the edge
On the EB140 Pre-milling you can only rectify the panel, it's
not necessary to perform the edgebanding process at the
same time.
To do this, proceed as follows:
1 - Pull back and lock the gluing unit in order to avoid stai-
ning the panel with glue (Fig. 30)
2 - Separate the inner and upper cutters up to the mark of
0030 (Fig. 31 and 32)
3 - Separate the upper and lower scrapers by turning one
turn approximately clockwise (Fig. 31 and 32)
(Figura 32)