Technical Specifications - Virutex EB140PLC Manuel D'instructions

INTRODUCTION
This Annex contains the instructions for the operation
and necessary adjustments of the new pre-milling unit
and the necessary adjustments for the panel feeder.
Reference is also made to the replacement and mainte-
nance operations necessary for these units.
WARNINGS REGARDING EDGEBANDER USE
The edgebander has been designed to apply edges made
from melamine, PVC, ABS, wood and other similar mate-
rials to boards made from wood and wood products. The
machine trims only those boards with 90° edges.
The use of other materials unlike those mentioned above
is forbidden; the user shall be the only party liable for
any damage caused.

TECHNICAL SPECIFICATIONS

(Figures A, B and C)
For any doubts on operation, adjustments and regula-
tions of the rest of the units, consult the Instructions
Manual EB140-EB140PLC.
Always connect the dust collection equipment.
Do not remove the safety protectors from the machine.
It is forbidden to make any modifications to the machine,
as doing so would violate its CE compliance statement.
The user is the only party liable for any da-
mage caused by inappropriate use of the
machine.
Working plane height: 902 mm
Minimum working width (board): 65 mm
Minimum working length (board): 140 mm
(Figura A)
EB140PLC Premilling / Annex operating instructions - 27