Virutex EB140PLC Manuel D'instructions page 37

(Figure 4.7)
P2
+ -
J
C
C
I
D
E
P1
P1
C
D
E
If it becomes necessary to reset the excess amount to 10 mm,
proceed as follows:
G
Loosen lock nut E (Fig. 4.7) on cylinder P1 and turn stopscrew
C (Fig. 4.7), removing it from or inserting it into support D
F
(Fig. 4.7), depending on whether you wish to decrease or in-
crease the excess amount, respectively. Attach lock nut E (Fig.
4.7) once again to finish the adjustment.
P1
4.2.3 Edge feeding speed control
The edge feeding speed leaves the factory pre-set so that the
edge reaches point B (Fig. 4.8) at its outlet and waits for the
board to arrive. If it becomes necessary to reset the speed,
loosen nut F (Fig. 4.7) and turn knob G (Fig. 4.7) clockwise if
you wish to reduce the speed, or counterclockwise if you wish
to increase it.
EB140PLC Premilling / Annex operating instructions - 37