Care And Maintenance - Russell Hobbs 23821-56 Manuel

5. Replace the lid.
6. Align the pips on the cap with the slots in the hole in the lid, fit the cap, and turn it clockwise to lock
it. Don't run the appliance without fitting the cap.
7. Check that the speed control is set to O.
8. Put the plug into the power socket.
9. Turn the speed control to the speed you want (1 = low, 2 = high).
10. Turn the speed control back to O to turn the motor off.
• Generally, large quantities, thick mixes, and a high ratio of solids to liquids require longer timings and
slower speeds.
• Smaller quantities, thinner mixes, and more liquids than solids require shorter timings and higher
speeds.
Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In this
•
direction, the knob is spring-loaded. When you let go, it'll return to O.
• To add ingredients while the blender is working, remove the cap, pour the new ingredients through
the hole then replace the cap.
When you have finished:
• Switch the appliance off (O) and unplug it.
CRUSHED ICE
For best results, full the jug with between 150ml and 500ml of ice cubes.
Put the lid on the blender, then:
Turn the speed control to Y for a second or two, then release it.
1.
2. Check the results and repeat as required.
USING THE PERSONAL BLENDER
1. Unscrew the collar from the jug and carefully remove the blade unit.
2. Add the ingredients to the bottle. Don't fill past the 600ml marking.
3. Carefully fit the blade unit to the bottle then screw on the collar.
4. Lower the assembled bottle, blade unit and collar onto the motor unit.
5. Place the palm of your hand over the top of the bottle and press firmly downwards. Maintain this
pressure during processing or your blender won't operate.
Turn the speed control to Y for a second or two, then release it.
6.
7. Check the results and repeat as required.
8. To process continuously, turn the speed control to 1 or 2. Keep firm downward pressure on the bottle
with your hand.
9. Once processed, unscrew the collar, carefully remove the blade unit and fit the bottle lid.

CARE AND MAINTENANCE

1. Switch the appliance off (O) and unplug it.
2. Wipe the outside of the motor unit with a clean damp cloth.
3. Hand wash the removable parts.
¬ You may wash these parts in the top rack of a dishwasher.
` You may wash these parts in the dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface finishes. The
damage should be cosmetic only, and should not affect the operation of the appliance.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
.
4