Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Don't run the appliance without fitting the cap.
8.
Check that the speed control is set to 0.
9.
Put the plug into the power socket.
10. Turn the speed control to the speed you want (1 = low, 2 = high).
11. Turn the speed control back to 0 to turn the motor off.
•
Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer
timings and slower speeds.
•
Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and
higher speeds.
Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In
•
this direction, the knob is spring-loaded. When you let go, it'll return to 0.
•
To add ingredients while the blender is working, remove the cap, pour the new ingredients
through the hole, then replace the cap.
When you have finished:
1.
Switch the appliance off (0) and unplug it.
2.
Turn the jug anti-clockwise, and lift it off the motor unit.
CRUSHED ICE
For best results, full the jug with between 150ml and 500ml of ice cubes.
Put the lid on the blender, then:
Turn the speed control to Y for a second or two, then release it.
1.
2.
Check the results, and adjust.
OVERLOAD PROTECTION
This appliance is fitted with a device to protect it in the event it becomes overloaded or
overheats. If the appliance stops without warning for any reason, do the following:
1.
Switch off (O) and unplug the appliance.
2.
Allow the appliance to cool down for 15 min
3.
Once cooled down the protection device will automatically reset and the appliance can be
used normally again.
CARE AND MAINTENANCE
1.
Switch the appliance off (0) and unplug it.
2.
Wipe the outside of the motor unit with a clean damp cloth.
3.
Hand wash the removable parts.
` You may wash these parts in a dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface
finishes. The damage should be cosmetic only, and should not affect the operation of the
appliance.
To remove the blade unit from the jug:
1.
Remove the lid.
2.
Sit the jug upside down.
3.
Unscrew the collar.
4.
Remove the blade unit and seal.
5.
Hand wash the removable parts.
6.
Replace the blade unit and seal.
7.
Screw the collar back into place.
W
ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in electrical
and electronic goods, appliances marked with this symbol mustn't be disposed of with unsorted
municipal waste, but recovered, reused, or recycled.
4
Publicité
Table des Matières
