Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8315517
EMISSION CONTROL SYSTEM INFORMATION
The combustion process produces carbon monoxide, hydrocarbons, and oxides of nitrogen. Control of these
emissions is very important for personal and environmental health.
The following instructions must be followed in order to keep the emissions from your engine within Canadian
emission standards.
1. Do not remove or alter any part of the intake, fuel, or exhaust systems.
2. Do not alter or bypass the governor linkage or speed-adjusting mechanism to cause the engine to operate
outside its design specifications.
PROBLEMS THAT MAY AFFECT EMISSIONS
If you are aware of any of the following symptoms, have your engine inspected and repaired by a
qualified technician.
1. Hard starting or stalling after starting.
2. Rough idle.
3. Misfiring or backfiring under load.
4. Afterburning (backfiring)
5. Black exhaust smoke or high fuel consumption
REPLACEMENT PARTS
The emission control systems on your engine were designed, built, and certified to conform to Canadian emission
regulations. The use of genuine parts is recommended whenever maintenance is done to the engine. Genuine
replacement parts are manufactured to the same standards as the original parts. Using replacement parts that are
not of the original design and quality may impair the effectiveness of your emission control system.
It is the responsibility of the manufacturer of an aftermarket part to certify that use of the part will not result in a
failure of the engine to comply with emission regulations.
Visit www.princessauto.com for more information
270cc OHV Gas Engine with Electric Start
V2.7
13
Publicité
Table des Matières
