Assembling The Shower And Toilet Commode; Adjusting The Seat Height - Invacare Aquatec Ocean VIP Ergo Manuel D'utilisation

4 Setup
4.1 Safety information
WARNING!
– Check the parts for transport damage before
commissioning and contact your provider if
required.
– Ensure during assembly that the parts are
positioned correctly with respect to one
another.
– Self-locking screws/nuts or thread-locking
adhesive are used for several connections. If
these are loosened, they must be replaced by
new self-locking screws/nuts or they must be
secured using new thread-locking adhesive.

4.2 Assembling the shower and toilet commode

This section describes the assembly. Disassembly takes place
in the reverse order.
The armrest height, footrest height, footrest angle,
headrest, heel strap, tension of backrest cover and
accessories must be adjusted to optimally fit the user.

4.2.1 Adjusting the seat height

This section describes the assembly. Disassembly takes place
in the reverse order.
WARNING!
– Do not adjust the seat height of the commode
when someone is sitting on it.
1639504-C
All manuals and user guides at all-guides.com
The seat height must be adjusted on both sides
simultaneously.
1. Slightly raise the commode at the side part A.
2. Remove the four clips C (two on each side).
3. Set the correct height by simultaneously moving the
seat frame upwards or downwards on the four tubes
B of the base frame.
4. Bring the clip mounts on the side part in line with a
hole in the base frame.
5. Insert the four clips from the outside into the side part,
until the clip edges enclose the base frame tube B.
WARNING!
Risk of injury
– Make sure that all four clips are securely
fastened.
– Make sure that all four tubes are set to the
same height.
Setup
11