Care & Maintenance - PRO-POINT 8327835 Manuel D'utilisateur

V1.0
2. The tool may switch on, but fails to maintain power
when operated.
3. The tool may overheat, possibly starting a fire.
Test the tool by plugging it directly to the power supply. If it
powers on, change the extension cord with the correct rating
and as short as needed. The workpiece may also need to be
relocated closer to the power supply.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical
replacement parts when servicing.
3. Keep the tool handles clean, dry and free from oil/grease at
all times.
4. Maintain the tool's labels and name plates. These carry
important information. If unreadable or missing, contact
Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
CLEANING
1. Clean residue and debris from the nozzle before using the
tool. The debris can ignite when heat is applied.
2. Clean dust and debris from the air vents (B) with a small
brush. Hold the tool so the debris will not fall inside the vents.
Air must flow through the tool unimpeded. Clogged vents will
cause the tool to overheat. The tool may fail or reach a higher
temperature than intended and damage the workpiece.
3. Clean the housing with a damp cloth after work is complete
and allow to air dry before reusing.
Visit www.princessauto.com for more information
DIGITAL CONTROL ELECTRIC HEAT GUN 8327835
13