PRO-POINT 8327835 Manuel D'utilisateur page 11

V1.0
2.1 Try decreasing the distance between the heat gun and
workpiece, before increasing the setting to II or III.
3. Move the heat gun side to side to heat the area in front of
the scraper until the paint softens or blisters. Scrape
downwards in even strips. Do not rush as this may damage
the workpiece.
4. Remove the softened coating with a wire brush in difficult
to reach areas.
REMOVING AN ADHESIVE
Soften glue and other adhesives with applied heat. The steps
are similar to removing paint.
1. Follow steps 1 and 2 for removing paint. This alone may
soften the glue and allow the workpiece to separate.
2. Increase to setting II and move the heat gun over the
workpiece without focusing on one spot. This will reduce
the chances of heat damage while raising the workpiece's
temperature.
2.1 The material's mass and thickness may require longer
heating if you cannot focus the airflow directly on the
adhesive.
3. Gently pry the workpiece apart, applying heat as necessary
to keep the adhesive soft.
4. Once the workpiece is separated. Heat the adhesive and
scrap it away.
4.1 An alternative with delicate items is to place paper or a
rag on the glue and apply heat. The glue will stick to
the paper and can be peeled off. This should be done
on a lower setting to avoid igniting the material.
4.2 In difficult to reach spots, a wire brush or chemical
solution may be required to remove the remaining
adhesive.
Visit www.princessauto.com for more information
DIGITAL CONTROL ELECTRIC HEAT GUN 8327835
11