Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
2.
Do not operate this tool if the power cord is frayed or
damaged, as an electric shock or surge may occur, resulting
in personal injury or property damage.
2.1 Inspect the tool's power cord for cracks, fraying or
other faults in the insulation or plug before each use.
2.2 Discontinue use if a power cord feels more than
comfortably warm while operating the tool.
2.3 Have the power cord replaced by a qualified service
technician.
3.
Keep all connections dry and off the ground to reduce the
risk of electric shock. Do not touch plug with wet hands.
4. Prevent damage to the power cord by observing the
following:
4.1 Do not pull on the cord to disconnect the plug from
an outlet.
4.2 Keep cord away from heat, oil, sharp edges or
moving parts.
4.3 Never use the cord to carry the tool.
4.4 Place the electrical cord in a position that prevents it
from coming into contact with the tool and from
getting caught by the workpiece. The cord should
always stay behind the tool.
5.
Do not allow people, mobile equipment or vehicles to pass
over unprotected power cords.
5.1 Position power cords away from traffic areas.
5.2 Place cords in reinforced conduits.
5.3 Place planks on either side of the power cord to create
a protective trench.
6.
Do not wrap cord around the tool, as sharp edges may cut
insulation or cause cracks if wound too tight. Gently coil
cord and either hang on a hook or fasten with a device to
keep cord together during storage.
Visit www.princessauto.com for more information
DIGITAL CONTROL ELECTRIC HEAT GUN
8327835
7
Publicité
Table des Matières
