Before Each Use - PRO-POINT 8327835 Manuel D'utilisateur

V1.0
OPERATION
Letter references in parenthesis (A) refer to the included
Identification Key.

BEFORE EACH USE

1. Clear the work area of combustible or flammable materials.
2. Make sure the work area is well ventilated as there may be toxic
or irritating fumes from the paint or coating being removed.
3. Clean the nozzle of any residue from previous work.
HEAT GUN CONTROLS
The temperature range displayed is in Celsius only. Each
increase of 10°C equals an increase of 18°F.
1. Make sure the ON/OFF Switch (F) is in the OFF position before
connecting the power supply cord to a power outlet.
2. Push the ON/OFF Switch upwards to setting I to activate
the heating element and fan.
2.1 A slight oily odour is common when first used. This will
fade after a short period of time.
3. Push the switch to setting II or III as desired. See Specifications
for temperature ranges and airflow for each setting.
4. In setting II and III adjust the heat up or down in 10°C
increments by pressing the temperature control button (E).
Press on the right side to increase the temperature and on
the left side to decrease it.
5. Allow the heat gun to run for 1 minute to attain the
programmed level of heat.
6. Aim the stream of hot air at the workpiece for short
durations to avoid burning or damaging the workpiece. You
may also need to adjust the distance between the
workpiece and heat gun to achieve the desired effect.
Visit www.princessauto.com for more information
DIGITAL CONTROL ELECTRIC HEAT GUN 8327835
9