Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
2.
Place the support pole (#2) into the centre of the base.
3.
Tighten the 2 set screws (#6 and #7) in the base.
4.
Slide coolant tray collar (#4) onto the support pole. Slide it far
enough down so that at least 4 in. of pole is showing above
the collar.
5.
Secure the coolant tray (#5) in place by tightening the set screw.
6.
Place the fixed plate (#1) over the support pole. Secure it in place
by tightening its 2 set screws.
7.
It is strongly recommended that you mount the base to the floor
using 3/8 in. bolts of a type compatible with the floor surface.
MOUNTING A GRINDER
1.
If the grinder (or other stationary power tool) has rubber feet,
remove them. This will allow the grinder to sit flat on the
pedestal stand.
2.
Place the grinder on top of the pedestal stand, aligning the
mounting holes of both the grinder and the pedestal stand. Ideally,
the front of the grinder should be square with the front of the
mounting surface.
3.
Secure the grinder with the hardware described in its owner's
manual. If the mounting hardware is not listed, use a hex bolt not
exceeding 7/16 in. in diameter, two flat washers, a lock washer and
a hex nut.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical replacement parts
when servicing.
3.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
Visit www.princ essauto.com for more inform ation
Industrial Benc h Grinder P edestal Stand
9027913
5
Publicité
Table des Matières
