Appendix A: Diagnostics Overview - PR electronics 5437 Manuel De Produit

Incident Description
The device variable mapped to PV (and
analog out put current) is beyond its
operating limits.
Any other device variable is beyond its
operating limits.
The loop current has reached the
Current Output Upper Limit (UL) or
Output Lower Limit (LL) as configured
with command #147, and is no longer
corresponding to the PV value.
The analogue output current is being
simulated or disabled.
The configuration has changed since
this bit was last cleared (seen from
same master type, Primary- or
Secondary Master).
A sensor error (broken/shorted sensor)
is detected on Input 1
A sensor error (broken/shorted sensor)
is detected on Input 2.
This is only possible if Input type 2 is
<> "None"
A sensor error (broken/shorted sensor)
is detected on the CJC measurement
used for Input 1
A sensor error (broken/shorted sensor)
is detected on the CJC measurement
used for Input 2
The difference between measurements
on Input 1 and Input 2 is outside the
configured sensor drift limit
A sensor error (broken/shorted) is
detected on the primary sensor,
backup sensor is in use
A sensor error (broken/shorted) is
detected on the backup sensor,
primary sensor only is available
Configuration is temporarily invalid
< 3 seconds, e.g. while downloading
parameters
52

Appendix A: Diagnostics overview

Description LED reaction
Primary Value Out Flashing Red
Of Limits
Non-Primary Value Flashing Red
Out Of Limits
Loop Current Flashing Red
Saturated
Loop Current Fixed Flashing Red
Configuration No Impact
Changed
Primary Input 1 Flashing Red
error
Primary Input 2 Flashing Red
error
(only if Input 2 is
enabled)
CJC for Input 1 error Flashing Red
(only if used)
CJC for Input 2 error Flashing Red
(only if used)
Dual Input: Sensor Flashing Red
drift alarm
(only if enabled)
Dual Input: Backup No Impact
sensor OK, main
sensor error
Dual Input: Backup No Impact
sensor error, main
sensor OK
Configuration not Flashing Red
supported by device
5437V103-FR
Analog Output
NE-107 Class
Reaction
Enters configured Maintenance
Value required
No impact Maintenance
required
Enters configured If output range
Value check is enabled:
Failure
otherwise
Maintenance
required
Enters configured Function check
Value
No impact N.A.
Enters configured If no backup
Value input is available
and mapped to
PV, then failure
otherwise
maintenance
required.
Enters configured If no backup
Value input is available
and mapped to
PV, then failure
otherwise
maintenance
required.
Enters configured If no backup
Value input is available
and mapped to
PV, then failure
otherwise
maintenance
required.
Enters configured If no backup
Value input is available
and mapped to
PV, then failure
otherwise
maintenance
required.
Enters configured if sensor drift =
Value error => failure
otherwise
maintenance
required.
No impact Maintenance
required
No impact Maintenance
required
Value is held Failure
(freeze)
User action
Reconnect or repair sensor
Reconnect or repair sensor
Reconnect or repair sensor
N.A.
N.A.
Reconnect or repair sensor
Reconnect or repair sensor
Reconnect or repair sensor
Reconnect or repair sensor
Reconnect or repair sensor
Reconnect or repair sensor
Reconnect or repair sensor
N.A.
Error
#
0
1
2
3
6
10
11
12
13
14
15
16
17