Panasonic WX-SR202DNP Mode D'emploi page 43

● When performing wireless synchronization, one system (receiver) must be set as main
system which will become the reference for the synchronization of all the other systems
that are set as sub-systems.
● The wireless synchronization is performed when the reference antenna (the antenna
connected to the [ANTENNA 1] connector) of the main system is detected by the
reference antenna of the sub-systems.
● Place the reference antenna of the main system so as to have all other reference
antennas within its range, choosing the antenna field so as to make its coverage area
resemble that on page 37.
● Choose the antenna field and placement of the reference antenna of sub-systems and
all other antennas as shown on page 39 in order to avoid interference with other
systems.
● When a large number of systems will be installed in the same room or
adjacent rooms, set a small field selection and place the antennas in
Important
such a way as to cover the whole usage area by dividing it into circles
representing the coverage areas (or squares representing the
corresponding coverage areas) with antennas at the center.
● When a large number of systems will be installed in the same room or
adjacent rooms, make sure the sum total for the total number of
antennas and total number of microphones does not exceed the
following condition.
2×n+m<31
n: Number of antennas
m: Number of microphones
PUQX1039ZAV1_WX-SR202DNP_OI_en-fr.indb
Example of when same room: Up to 8 microphones
Set as main system
WX-SR204DNP
WX-SE200DNP
Set as sub-system
WX-SR204DNP
WX-SE200DNP
Set as sub-system
WX-SR204DNP
WX-SE200DNP
43
WX-SA250P
WX-STx00P
WX-STx00P
WX-STx00P
43
2022/04/27 13:17:42