Lubrication; Spare Parts - LGB 99 6001-4 Serie Mode D'emploi

the fluid into smoke.
Only use LGB Smoke and Cleaning Fluid (50010). Other
fluids may damage your locomotive.
Attention! Never touch the heating element in the center
of the smoke generator. It is hot and fragile.

Lubrication

The side rod ends should be lubricated occasionally
with a small amount of LGB Maintenance Oil (50019).
Replacing the light bulbs Lanterns:
– Remove the ring around the lantern lens.
– Carefully pry the lens away from the lantern.
– Using tweezers, remove the bulb.
– Plug in new bulb.
– Reassemble.
Replacing the smoke generator
– Pull the safety cover out of the smoke stack (Fig. 3).
– Use pliers or tweezers to pull the old smoke genera-
tor out of the stack (Fig. 4).
– Cut the wires to the old generator and attach them
to the replacement generator (Fig. 5).
– Insulate the connections and push the replacement
generator into the stack.
– Reassemble.
Changing Traction Tires
– Remove the hex nut on the rear drive wheel with the
traction tire.
– Remove side rod.
– Use a small, straight-blade screwdriver to pry the
old traction tire out of the wheel groove.
– Use a small, straight-blade screwdriver to gently pry
the new traction tire into the wheel groove.
– Make sure that the traction tire is seated properly in
the wheel groove.
– Reassemble.

Spare Parts

50010 Steaming and Cleaning Fluid
50019 Maintenance Oil
63120 Brushes with bushings, 8 pieces
63218 Standard Pick-Up Shoes, 2 pieces
65853 Stack, 5V
68511 Plug-In Bulb, Clear, 5V, 10 pieces
69104 Traction Tire 37.5 mm, 10 pieces
7