Lubrication - LGB Stainz Mode D'emploi

Masquer les pouces Voir aussi pour Stainz:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SERVICE

Lubrication

The axle bearings and the side rod bearings should be lubri-
cated occasionally with a small amount of Märklin-Oil (7149).
Replacing the light bulbs
Front lantern: Carefully pull the cable and light bulb out of
the lantern. Replace the bulb. Reassemble.
Rear lantern: Carefully pry the lens away from the lantern.
Using tweezers, remove and replace the bulb. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the smoke generator
• Pull the safety cover out of the smoke stack.
• Use pliers or tweezers to pull the old smoke generator out
of the stack.
• Cut the wires to the old generator and attach them to the
replacement generator.
• Insulate the connections and push the replacement
generator into the stack.
• Reassemble.
Replacing the traction tire
• Remove the two hex head screws that attach the side
rods to the rear wheels.
• Remove the side rods from the rear wheels.
• Use a small, straight-blade screwdriver to replace the trac-
tion tire: Pry the old traction tire out of the wheel groove.
• Gently insert the new traction tire into the wheel groove.
• Make sure that the traction tire is seated properly in the
wheel groove.
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

22211

Table des Matières