Technical Information; Components - Meister BEH 600 C Traduction Du Manuel D'utilisation Original

5410050-Elektrohob-man 21.02.14 13:58 Seite 46
2 – Technical information
Technical data
Current supply
Rated power
requirement
Motor speed
(idle mode)
Blade width
Cutting depth
(adjustable)
Max. planing/
rebate width
Power cord
Insulation:
double-insulated
Note technical data on rating plate!
Technical alterations reserved.
Noise emission/vibration
Noise emission
L : 90,4 dB(A)
pA
L : 101,4 dB(A)
WA
Measuring inaccuracy:
K : 3 dB
pA
K : 3 dB
WA
Hand/arm vibrations
2
a : 2,372 m/s ;
h
Measuring inaccuracy K: 1,5 m/s
Noise/vibration information
Measured values determined in
accordance with EN 60745-1.
The specified vibration emission value
was measured in accordance with a
standardised test procedure and can be
46
All manuals and user guides at all-guides.com
220-240 V~/50 Hz
600 W
-1
n = 17000 min
0
82 mm
0-2 mm
82 mm
200 cm
2
used in order to compare one electrical
tool with another.
The specified vibration emission value
can also be used for preliminary
evaluation of the disturbance.
CAUTION! The vibration emission
value may fluctuate from the
specified value during use of the
electrical tool. These fluctuations will
depend on the way in which the tool is
used.
Safety measures must be taken
in order to protect the operator.
As a result, the evaluation of the
disturbance must be made whilst
taking account of the actual
conditions of use. (All parts of the
operating cycle must be taken into
account for this purpose. This also
includes times in which the tool is
switched off and times in which it is
switched on, but is running without
load.)
3 – Components
1
7
2 3 4 6
5
8