Publicité
All manuals and user guides at all-guides.com
Building:
Sand the hinges on the underside to obtain enough rudder
deflection.
Use a triangle to determine the center of the horizontal
stabilizer. Mark 70 mm from the leading edge. Glue the fuselage
boom on the right position of the stabilizer surface.
IMPORTANT! On the aft side of the fuselage boom, the hole for
mounting the tailskid is already drilled.
Apply glue on the root and bottom of the vertical fin and glue ut
to the stabilizer and boom as shown. Make sure the fin is
perpendicular to the stabilizer Stick the decals on the fin.
Cut the following plastic parts from the frame and insert them as
follows: A8, B3, B4, B5, B1. Important : place the front wing
holder B1 70 mm back from the rear edge of the motor.
Insert the fuselage boom to the indoor power system. Install the
propeller and fix it firmly with the washer and the nut. Put the
spinner onto the axle.
Carefully install the rubber tires onto the wheels and install the
wheels on the main landing gear. Put on the stoppers. Insert the
main landing gear into part B1.
Glue the tail skid into the hole in the fuselage.
Wings:
Glue the longest beech rods to the leading (front) edge and the
shorter rods to the trailing (rear) edge of the right and left wings.
Secure them with transparent tape. Put the decals on the wings.
Place the receiver mount B6 on the CG point and glue it to the
fuselage boom. Mount your receiver using the supplied double-
sided tape. Fix the antenna on the fuselage boom with a tape.
NEVER SHORTEN THE ANTENNA
Mount the 2 servos on the main frame precisely as shown and
insert the screws through grommets and small screws. Be
aware of the mounting direction of the servos.
Install the speed controller using the supplied double-sided tape
on plastic part B5. Use the supplied rubber bands to mount the
battery into part B5.
Connect your radio equipment (see your manual) and put the
servos in the neutral position.
Insert the control horns to the slots on the stabilizer and the fin
and fix them with the retainers. Insert the push rods into plastic
support A8 and adjust the length. Bend the other end of the
push rod and connect the control horns and servos.
Elevator deflection: +/- 10 mm up & down
Rudder deflection: 20-25 mm to each side
The wing is mounted into the plastic supports.
The centre of gravity is located 55 mm back from the leading
edge of the wing. Use the battery to correct the CG position.
First flight
First check the range of your radio.
The model can be hand launched: move the trottle stick up fully
and push the model horizontally. A ground start is possible if the
surface is smooth enough. The model can take off after a few
meters.
4
- Slowmo
Publicité
