Please Read Immediately; Important Information; Intended Use; Regulations / Safety Information - Dimplex AWP 30 HLW Instructions D'installation Et D'utilisation

1
1 Please Read
Immediately

1.1 Important Information

ATTENTION!
The (painted) steel coverings, particularly the upper cover plates, are not
designed to withstand large forces!
ATTENTION!
High centre of mass, low overturning moment!
ATTENTION!
When installing the on-site pipework, ensure the pipes do not get
contaminated (flush pipes before connecting hot-water heat pump)!
ATTENTION!
Only operate hot-water heat pump when filled with water!
ATTENTION!
Before opening the hot-water heat pump, unplug mains plug and observe
possible coasting of ventilator!
ATTENTION!
Ensure water does not come into contact with the operator controls.
E-2
All manuals and user guides at all-guides.com

1.2 Intended Use

This device is only intended for use as specified by the manufac-
turer. Any other use beyond that intended by the manufacturer is
prohibited. This includes the user's abiding by the manufacturer's
product brochures. Please refrain from tampering with or altering
the device.
1.3 Regulations / Safety
Read these installation and operating instructions before start-up!
Work on the hot-water heat pump is to be performed by qualified persons
only! Observe the accident prevention regulations!
Information
ATTENTION!
The hot-water heat pump is exclusively used to heat water
for domestic use and drinking water within the specified op-
erating temperature limits!
The construction and design of the hot-water heat pump
complies with all relevant EG directives. (see also CE decla-
ration of conformity).
The technician must ensure that the refrigerant is flushed
adequately to allow maintenance and repair work on refrig-
erant circuit components without risk. Refrigerant must be
properly used and disposed of; it must not be released into
the environment!
The refrigerant circuit is hermetically sealed. It contains the
Kyoto protocol approved refrigerant R134a with a GWP
value of 1300. It is CFC-free, does not deplete ozone and is
non-flammable.
When working on the hot-water heat pump, always discon-
nect the power supply (disconnect plug).
When connecting the hot-water heat pump to the power sup-
ply, the relevant VDE, EN and IEC standards are to be ful-
filled. Also observe the technical connection requirements of
the electrical utility companies.
ATTENTION!