Cleaning The Combustion Chamber - Sovelor CYNOX50G Manuel D'utilisation Et De Maintenance

• Run the procedures described in paragraphs 4.7 and 4.8 to
measure combustion parameters and check that combustion is
stable and clean.
6.6 CHECKING THE THERMOSTATS
Inspect the fan thermostat and manual reset safety thermostat as
follows:
• Remove the side inspection panel
• Find the two thermostats attached to the front wall of the
combustion chamber
• Clean with a dry cloth, taking care not to damage the thermostats
• Close the side inspection panel
Inspect the burner thermostat as follows:
• Remove any air outlet connection ducts
• Clean with a dry cloth, taking care not to cut or bend the capillary
tube.
6.7 CLEANING THE INTERIOR OF THE HEATER
For thorough cleaning, the heater can be cleaned and washed inside
and outside with water. Always do as follows:
• disconnect the electrical cable and remove it from the outlet
• completely close all access panels
• do not use water jets at a pressure exceeding 70 bar at a distance
less than 30 cm
L-L 195.00-BM
EN
• completely dry all parts before reconnecting the electrical cable

6.8 CLEANING THE COMBUSTION CHAMBER

To maintain the burner's high efficiency and prolong its life, the
procedure described in this paragraph must be done at least once at
the end of the work season or more frequently if there is an
excessive build-up of soot. Excessive soot may be caused by poor
chimney draught, poor fuel quality, poor regulation of the burner, or
more or less frequent alternation of burner starts and stops. Pay
attention during operation: pulsations at start may be due to
excessive amounts of soot.
To access the combustion chamber:
To access the burner:
• Remove the two side fixing screws (A) on the fan group, slide the
fan group (B) backward and rotate it downward.
• Remove the burner
• Clean with compressed air or a metal brush
Warning
After any technical work, always check that the heater
works correctly.
34 / 60