Publicité
Les langues disponibles
Les langues disponibles
7
7
Start-Up
7.1 General Information
To ensure that start-up is performed correctly, it should only be
carried out by an after-sales service technician authorized by the
manufacturer. Only then can an extended warranty period of
3 years in total be granted (see Warranty Service).
7.2 Start-Up
The following items need to be checked prior to start-up:
„
The heat pump must be fully connected, as described in
Chapter 6.
„
Any valves that might impair proper water flow in the water
circuit must be opened.
„
The air intake and air outlet paths must be clear.
„
The ventilator must turn in the direction indicated by the ar-
row.
„
The remote control must be operational.
„
Ensure the condensate outflow functions.
„
After connecting the operating voltage and switching on the
swimming pool heat pump, there will be a pre-programmed
5-minute compressor pause time before the heat pump
starts up.
„
The bypass and regulator valves must be set so that the
minimum water flow is in accordance with the Device Infor-
mation. The following maximum temperature spreads be-
tween water inlet and water outlet are set for the operating
point.
External air tempera-
Max. temperature spread
ture
between water inlet and water
From
To
18° C
20° C
15° C
18° C
E-6
All manuals and user guides at all-guides.com
8
8.1 Heat Pump Remote Control
The heat pump can be switched on and off inside the building
(Frost-free and dry) via the remote control. The heat pump is op-
erational at water temperatures <10°C. In order to ensure frost
protection, continuous operation of the filter pump must be en-
sured on-site when there is a danger of frost. This can be imple-
mented by using a frost protection thermostat, for example. The
temperature of the swimming pool water is adjusted via the ad-
justable transformer on the remote control.
The water temperature operating limits are between +10°C and
+40°C.
1)
2)
3)
4)
Position max. (right-hand stop), hot water set temperature:
40 °C.
outlet
Position min. (left-hand stop), hot water set temperature: 10 °C.
The setting knob has two setting rings for mechanically limiting
6-7 K
the setting range. (Note: before adjusting the setting rings, the
5-6 K
setting knob must be set to the approximate middle of the desired
setting range.)
Description of Functions
Switch on / off
The green LED lights up independent of the switch position
(indicating the heat pump is operationally ready)
Has no function
Setpoint regulator for water temperature
Publicité
Chapitres
