Faber INCA HC Instructions D'installation page 13

All manuals and user guides at all-guides.com
FOR INSTALLATION WITH LINERS
WARNING
!
When building a custom hood,
always follow all applicable codes and
standards.
The Inca HC SS can be used with
WARNING
custom cabinetry and hoods 30"
wide and up. Choose either a
custom liner or our Standard Liner
designed for 30" and 36" wide
installations.
Liners create a perfectly-sealed,
underside of your custom/wood
hood.
The Standard Liners are made
up of two sections: a larger, rear
section (pre-cut out for insertion of
the Inca Smart) and a front section
for a total adjustable depth between
16" and 17 7/8".
!!! IMPORTANT NOTE: YOU
MUST REMOVE THE ADDITIONAL
PERFORATED SECTION
AROUND THE PRE-CUT-
OUT WHEN INSTALLING THE
STANDARD LINER WITH THE
INCA HC SS MODEL.
Consider the shape, size, and
weight of the Inca HC SS and Liner
of the custom/wood hood.
CUSTOM/WOOD
HOOD
1. The custom/wood hood must have a sturdy base
(3/4" plywood recommended) to accomodate the cut-
out for the Inca HC SS. The base must be recessed
to accomodate the height of the Liner (see LINER
DIMENSIONS on Page 12). The Liner attaches to the
bottom of the base using screws appropriate for the
size and material of your custom/ wood hood. The Inca
HC SS inserts into the cut-out in the Liner and base.
2. Position the rear section of the Liner so that it abuts
the back edge of your custom/ wood hood. Using a
pen, trace the outline of the pre-cut out. Remove the
Liner and proceed to MAKE YOUR CUT-OUTS. Install
both sections of the Liner and proceed to INSTALL
THE Range hood.
13