Reset Function; User Mode - Zanussi ZDF26011XA Notice D'utilisation

SETTINGS
PROGRAMME SELECTION MODE
The appliance is in programme selection mode when after the activation all the programme indicators
come on and the display shows two horizontal status bars.
When the appliance is in programme selection mode it is possible to set a programme.
If the control panel does not show this condition, do the Reset.

RESET FUNCTION

Press and hold simultaneously
With this function you can cancel the running programme or the delay start.

USER MODE

While the appliance is in programme selection mode:
1. Press and hold
• The indicators
In user mode can be changed:
• The level of the water softener according to the water hardness.
• The deactivation of the rinse aid dispenser when you want to use the Multitab option without the rinse
aid.
These settings will be saved until you change them again.
22
All manuals and user guides at all-guides.com
and until the appliance is in programme selection mode.
and .
, and starts to flash.