Using The Remote Control; Batteries For The Remote Control - Sharp LL-M17W1U Mode D'emploi

Using the remote control

Use the remote control by pointing it towards the remote sensor window on the monitor. Objects between
the remote control and sensor window may prevent proper operation.
Cautions regarding use of remote control
- Do not expose the remote control to shock.
In addition, do not expose the remote control to liquid, and do not place in an area with high humidity.
- Do not install or place the remote control under direct sunlight. The heat may deform the unit.
- The remote control may not work properly if the remote sensor window of the monitor is under direct
sunlight or strong lighting. In such case, change the angle of the lighting or monitor, or operate the
remote control closer to the remote sensor window.
- Do not use the remote control simultaneously with remote controls of other equipments.

Batteries for the remote control

Before using the monitor for the first time, install two ("AAA" size, UM/SUM-4) batteries (supplied).
When the batteries become depleted and the remote control fails to operate, replace the batteries with
new ("AAA" size, UM/SUM-4) batteries.
1
Open the battery
cover.
Slide the cover while
pressing the ( ) part.
CAUTION!
Improper use of batteries can result in chemical leakage and/or explosion. Be sure to follow the
instructions below.
- Place batteries with their terminals corresponding to the (+) and (–) indications.
- Different types of batteries have different characteristics. Do not mix batteries of different types.
- Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new battery
and/or cause the old battery to leak chemicals.
- Remove batteries when they become weak.
Chemicals that leak from batteries can cause a rash. If chemical leakage is found, wipe with a cloth.
- The batteries supplied with the product may have a shorter life expectancy due to storage conditions.
- If the remote control will not be used for an extended period of time, remove the batteries from the
remote control.
g01.P65
All manuals and user guides at all-guides.com
Remote control
2
Insert two ("AAA" size,
UM/SUM-4) batteries.
+
-
+
Position the positive and
negative ends of the batteries
as indicated in the compartment.
E11
11
3
Close the battery
cover.
-
Engage the claw on the
cover into the battery
housing and slide shut.
8/22/2003, 6:02 PM