Connection With The Control Kit (Optional); Preparing The Remote Control Unit - Sharp PN-A601 Manuel D'installation

Connection with the Control Kit (optional)

Caution
• When attaching the remote control sensor box, turn the
main power switch OFF.
1. Insert the remote control sensor box connection cable
into the control kit terminal.
Control kit terminal
TIPS
• When connecting the control kit, select whether to use
the remote control sensor and the brightness sensor
on the remote control sensor box or the monitor with
CONTROL KIT SETTING on the SETUP menu.
1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
batteries (R-6 ("AA" size) x 2) with their plus (+) and minus
(-) sides oriented correctly.
3. Close the cover.
6
E
Remote control
sensor box
Connection cable

Preparing the Remote Control Unit

When attaching the remote control sensor box to this
monitor
Attach the remote control sensor box to the location shown in
the following illustration;
For the monitor in
landscape orientation
1. Unscrew the screw in the monitor's remote control
sensor box mounting hole.
2. Secure the mounting bracket by screwing the screw
removed in Step 1. in the monitor's remote control
sensor box mounting hole.
3. Adjust the angle of the remote control sensor box, and
secure it with the fixing screw, so that it may accurately
receive signals from the remote control unit.
Remote control sensor box
mounting hole
Remote control
sensor box
For the monitor in
portrait orientation
Mounting bracket
Screw (Screw
removed from
the remote control
Angle sensor box
adjustment mounting hole)
Fixing screw