Supplied Components; Preparing The Remote Control Unit - Sharp PN-HM851 Manuel D'installation

If any component should be missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Cable clamp: 2
 Cable clamp (affixing type): 3
* SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Preparing the Remote Control Unit

1. Place your finger on the part marked with the ▲, and then pull the cover off.
2. See the instructions in the compartment and put in the supplied batteries (R03 ("AAA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.

Supplied Components

 Power cord: 1
 R03 battery ("AAA" size): 2
 CD-ROM (Utility Disk for Windows): 1
 Setup Manual (this manual): 1
 Specification sheet
 RS-232C conversion cable (3.5mm mini stereo jack): 1
 Logo sticker: 1
 USB flash drive / SD card cover: 1
 USB flash drive / SD card cover fixing screw: 1
 Wireless LAN antenna: 2
5
E