Troubleshooting - JVC XV-NP10S Manuel D'instructions

Additional information

Troubleshooting

Power
Power does not come on.
\ Power plug is not inserted securely. Plug in securely.
Operation
"REGION CODE ERROR!" is shown on the TV screen.
\ Region code of the inserted disc does not match the player.
Check the region code of the disc printed on the disc jacket.
Operation is not possible.
\ Microcomputer malfunction due to lightning or static electricity.
Turn off the power and unplug the power cord, then connect the
power cord again.
\ Moisture condensation caused by a sudden change of
temperature or humidity. Turn off the power, then turn it on a
few hours later.
\ The disc does not allow the operation, or an unplayable disc is
inserted. Check and replace the disc (see page 2).
[TRAY LOCK] is displayed on the display window and the
disc tray does not open.
\ When you press 0 while pressing down 7 on the player in
standby mode, the tray lock function is activated. The disc tray
cannot be opened or closed in this status. To release this
status, press 0 while pressing down 7 on the player in standby
mode. ([LOCK OFF] is displayed on the display window.)
Picture
Picture is noisy.
\ The player is connected to a VCR directly and the copyguard
function is activated. Connect the player so that the picture
signal flows directly to the TV.
\ With some discs, the picture may be blurred when [PICTURE
SOURCE] is set to [FILM] or [AUTO]. Set [PICTURE SOURCE]
to [VIDEO(NORMAL)] or [VIDEO(ACTIVE)].
Picture is distorted when using COMPONENT VIDEO OUT or
S-VIDEO output jack(s).
\ Both the component connection and S-video connection are
made. Disconnect the unused one.
No picture is displayed on the TV screen, or the picture is
devided in two parts.
\ The Progressive scanning mode is activated. Change the
scanning mode to the Interlaced scanning mode by doing one
of the following:
- When the VIDEO SIGNAL SELECTOR is set to "480p,"
set the VIDEO SIGNAL SELECTOR to "480i."
- When the VIDEO SIGNAL SELECTOR is set to "REMOTE,"
press and hold down VFP - PROGRESSIVE SCAN for a few
seconds.
34
Audio
DVD VIDEO disc playback sound level is lower than TV
broadcast sound level.
\ Set the [D.RANGE CONTROL] preference to [TV MODE] (see
page 30).
Analog audio output is distorted.
\ Set the [OUTPUT LEVEL] preference to [LOW] (see page 30).
MP3/WMA/JPEG/MPEG-4/DivX
No sound and/or no picture comes out.
\ MP3/WMA/MPEG-4 disc is recorded with the "packet writing
(UDF format)." It cannot be played.
\ Check the files you want to play back.
Files (tracks) are not played in the recorded order.
\ This player plays the files in the alphabetic order. So, the
playback order can vary.
WMA files cannot be played back.
\ The file is copy protected.
\ The file is recorded with a bit rate under 48 kbps. The player
does not support such WMA files.
MPEG-4 files cannot be played back.
\ The format of the file is not asf.
DivX files are played back without sound.
\ This player can play back the MP3 sound for the audio part of
the DivX files. Select the proper audio CODEC when making
DivX files.