Troubleshooting - JVC CU-VD3U Manuel D'utilisation

Troubleshooting

Trouble
CU-VD3
Cannot turn the power
on.
The burner and AC
adapter is hot.
Cannot open the disc
tray.
Reading fails.
Writing fails.
The writing time is too
long.
Make sure the AC adapter and power cord are connected
properly.
This is not a malfunction.
If the burner is abnormally hot, remove the AC adapter and
consult your authorized dealer.
A disc cannot be ejected by pressing the eject button if data
is being written to the disc. Wait until writing finishes.
If a disc cannot be ejected with the eject button:
• Remove and insert the AC adapter, then press the eject
button again.
• If the disc cannot be ejected using the above method,
remove the AC adapter and all other connections. Insert a
thin rod of about 5 cm into the force eject hole located on
the right side of the eject button. The disc tray will be
ejected for about 1 cm, pull out the disc tray manually and
take out the disc.
Insert the disc with the label facing up.
Make sure the disc tray is not dirty.
Make sure the writing surface of the disc is not damaged.
Make sure the special-shaped discs are not used.
Make sure the audio CD complies with the CD-DA standard.
(Copy-control CDs cannot be played.)
For CD-R or CD-RW, make sure it is not recorded using the
packet-write method.
Make sure an appropriate disc is being used. (A P. 4, 17)
Use discs recommended for the burner. (A P. 4, 17)
Make sure that a new disc is used for DVD-R.
Insert the disc with the label facing up.
Make sure the disc tray is not dirty.
Make sure the writing surface of the disc is not damaged.
Make sure the special-shaped discs are not used.
The time taken for writing may be longer depending on the
usage environment and conditions of usage. This is not a
malfunction. It is the performance of this burner.
Action
EN
FR
ES
15